Note that it may take a few minutes for your mining rig’s address to appear in this list if you’ve just recently powered it on. If this is a short list (or a list of one), then you can simply try each address. If you have a typical network configuration, your mining rig will have a “dynamic” type address, so you can ignore the static ones. This should give you a list of all the IP addresses on your local network. If you get an IP address here, great-make a note of it and skip the rest of these bullets (for most of you, the IP address will start with ).
#Cgminer usb device selection mac
I’m going to assume that you’re using Windows 7-if you’re on a different Windows version or a Mac you can Google the equivalent for your OS or contact me if you get stuck.
Make sure that your rig is powered up and connected to your internet router, and then head over to your desktop computer. Obtaining your rig’s IP address should be pretty straightforward, although depending on your network configuration some methods may not work for you. You’ll need a couple things before you can begin: your rig’s IP address, and an SSH client. There should almost never be a reason to plug a monitor, keyboard, and mouse into your rig directly, although you can certainly do that if you wish. The easiest way to manage your rig is to connect to it from another computer via SSH. Optional/Advanced: Rig Management Connecting to your rig via SSH While you can certainly stop here if you wish, most of you will likely want to monitor mining progress directly on your rig as well. The power button (and LED)-use this to turn your rig on and off. The mining process will always start automatically about a minute after you power it on. Press the power button again to turn the rig back on. Press it once to shut down (if the rig doesn’t power down within 20 seconds or so, simply hold the power button for 5 seconds). You can shut down your rig with the power button (located next to the LED built into the corner of the crate-see image below). It’ll take about 5-10 minutes for your pool stats to stabilize. You should be able to log into your mining pool and monitor your hashrate (note that the hashrate given by pools is a very rough estimate and will fluctuate +/- 20% of your actual speed) and mining income. In about a minute, your rig will automatically connect to your mining pool (your mining credentials are already pre-configured for you) and begin mining-you’ll probably notice the GPU fans spin up when that happens. That’s it! Your mining rig should now be in the process of booting up. Inspect the rig to make sure that the GPU power cables are still snug, and weren’t pulled loose during the unpacking process.Ĭonnect the power cord and switch on the PSU. Carefully cut each tie with a pair of scissors, and discard them. These ties are a precaution in case the box was inverted at any point during the shipping process, and are no longer necessary (and may interfere with the operation of the GPU fans). Locate the three (3) cable ties that are securing each GPU (see image below).
#Cgminer usb device selection manuals
The bag contains your power cord, USB stick, and various manuals & extra cables that came with your hardware. (Click on any of the images in these instructions for larger versions.) Setting up your rig for the first time Step 1: Unpack your new rigĬarefully open the box, remove the packing materials (take care that the packing paper and bubble wrap isn’t caught on anything as you remove it from the rig), and lift the rig straight up and out of the box.Ĭheck the shipping box for a small plastic bag and set it aside.
Don’t worry, the process is simple-you’ll be mining in a couple minutes! Thank you for purchasing a custom CryptoBadger mining rig! The following instructions will guide you through the set up process.
0 kommentar(er)
